Niveo Professional
Design Guide

How to size uplinks for an SDVoE network

Count the flows that can cross each link at the same time. A device count alone cannot tell you where the network will run out of capacity.

· 5 min read

Start with the signal routes

List transmitters, receivers, and their maximum stream rates. Draw the routes your operators actually use. A stream that stays on a single switch does not consume an inter-switch link.

Check the busiest uplink

Map each simultaneous flow to the uplinks it crosses. Account for replication across separate links and inspect each direction independently. Use the endpoint vendor’s rates and confirm the expected traffic with counters during commissioning.

Run the failure scenario

Repeat the calculation after removing one link or switch, if the project requires resilience. Document the resulting path and the load it must carry.

Further reading